Technical Bulletin
Marine Remover
|
|
Technical Bulletin |
|
|
Marine Remover |
||
|
ALLPRO®
Corporation |
AP7590 - 21266 |
| Description | ALLPRO® Marine
Remover™ is a fast acting, premium thick and brushable paint stripper.
It is the strongest remover for multiple layers of paint, epoxy and
polyurethane. Marine Remover can be applied to wood, masonry, metal and
concrete.
|
| Prominent Features |
|
| Uses | Ideal for
removing paint, polyurethane, epoxy, and enamel.
|
| Limitations | Do not use on
linoleum, plastic, rubber, asphalt tile, fiberglass, or other
synthetics.
|
| Surface Preparation |
Carefully read all cautions and instructions. Protect hands with
solvent-resistant gloves and eyes with safety glasses.
|
| Application | Carefully read
all cautions and instructions before use. Pour Marine Remover into a
metal container and apply with a brush. If applying to a vertical
surface, begin application at the bottom. Brush on a thick, liberal coat
to one small area at a time, up to 3' X 3'. Brush in one direction
only because brushing back and forth will destroy the built-in
evaporation retardant and reduce effectiveness. Allow stripper time to
work. It will loosen most finishes in 10 - 30 minutes. Remove loosened
finish by gently scraping in the direction of the wood grain with a flat
scraper.
|
| Clean Up | Wipe
surface with mineral spirits. A toothbrush or pointed stick will remove
finish from recesses. Surface must be clean and dry before refinishing.
Clean up used rags, paper and waste promptly. Take residual material
outdoors, allow liquid to evaporate, and then dispose in a metal
container in accordance with state, local, and federal regulations. Do
not mix with any other product.
|
| Disposal | Contains organic
solvents which may cause adverse effects to the environment if disposed
of improperly. Place empty containers in normal refuse for
disposal. Contact your local sanitation department or household
hazardous waste coordinator for information concerning possible reuse or
disposal of unused solvent-containing products.
|
|
Caution |
Technical Information |
| WARNING!
Using this product will expose you to Methylene Chloride which is known
to cause cancer. DANGER! May be fatal or cause blindness if swallowed. Vapro harmful. Skin
and eye irritant. Contains Methylene Chloride, Xylene, Petroleum Distillate, Dipropyl Glycol Methyl Ether and Methanol. Methylene Chloride has
caused cancer in certain laboratory animal tests. Risk to your health
depends on level and duration of exposure. Reports have associated
repeated and prolonged over exposure to solvents with neurological and
other physiological damage. For further information, refer to the
Material Safety Data Sheet. This product should not be used frequently
or on a regular basis without properly engineered air control systems
designed to prevent exceeding appropriate TLV. It is intended for
occasional use only. Whenever possible, use outdoors in an open air
area. Do not use in areas where vapors can accumulate and concentrate
such as basements, bathrooms or small enclosed areas. USE ONLY WITH
ADEQUATE VENTILATION TO PREVENT BUILDUP OF VAPORS. Open all windows and
doors. Use only with a cross ventilation of moving fresh air across the
work area. If strong odor is noticed or you experience slight dizziness,
headache, nausea, or eye-watering - STOP - ventilation is inadequate.
Leave area immediately. Do not take internally. Avoid prolonged or
repeated breathing of vapors or mist and contact with skin and eyes.
Contact of liquid or vapor with flame or hot surfaces will produce toxic
gases and a corrosive residue that will cause deterioration of metal.
Close container after each use. Do not reuse this container. For OSHA
controlled work place and other regular users - Use only with adequate
ventilation under engineered air controlled systems designed to prevent
exceeding appropriate TLV. For occasional use, properly maintained and
properly fitted NIOSH approved self-contained breathing apparatus for
chlorinated solvent vapors. A dust mask does not provide adequate
protection against vapors. Cannot be made non-poisonous! FIRST AID - IF SWALLOWED, call your
poison control center, hospital emergency room or physician immediately
for instructions to induce vomiting. IN CASE OF EYE CONTACT, immediately flush with
water for at least 15 minutes. Get medical attention. FOR SKIN
CONTACT, wash with soap and water. If irritation persists, get
medical attention. KEEP OUT OF REACH OF CHILDREN.
Manufactured For:
|
Packaging:
'F' style metal containers 2 gallons per case 6 quarts per case Weight per Gallon: 10.3 lb/gal excluding container Boiling Range: 103º - 395 ºF Vapor Density: Heavier than air % Solids By Weight: 2% % Solids By Volume: ~2% Photochemical Reaction: Non-Photochemically reactive Flash Point: No flash to boiling CPSC Flammability Classification: N.A. Storage: Store in a cool place. Exposure to high temperatures or prolonged exposure to sun can cause can to leak or swell. MAX Vapor Pressure: 100mm Hg at 20º C Air Quality Data: VOC 181 g/l Analysis: |