Technical Bulletin
Spray Enamel
|
|
Technical Bulletin |
|
|
Spray Enamel |
||
|
ALLPRO®
Corporation |
AP7000 - 11062 |
| Description | ALLPRO
Spray Enamel is a high performance coating which provides extra hiding
on most interior and exterior applications. With a properly prepared
surface, this tough coating prevents corrosion. Its fast drying formula
is non-toxic when dry. The high gloss finish provides easy care.
|
| Prominent Features | »
Fast drying » Interior & exterior use » Prevents corrosion » Tough coating » Tamper-proof matching colored cap » Full length draw tube ensures maximum delivery per can » Internal heavy-disc mixer for faster, more thorough paint mixing
|
| Uses | Excellent
for wood, metal, furniture, wicker, shop, industrial and other uses.
|
| Limitations | Galvanized
surfaces should be primed prior to application with a galvanized primer.
|
| Surface Preparation | Clean
surface thoroughly, removing all dirt, grease, oil, soapy film, rust,
moisture, etc. and cover adjacent areas to protect from spray mist.
|
| Application | Use
in well ventilated area. Shake can vigorously for one minute before
spraying and occasionally while in use. Hold can 8 - 10 inches from
surface to be sprayed. Spray at room temperatures between 70ºF - 90ºF
(21 - 32ºC). For best results, apply thin even coats – two thin coats are
better than one heavy one. Recoat within 2 hours or after 48 hours. If nozzle clogs
during use, turn spray button ¼ turn or remove and clean button
slot. Do not stick objects into can opening.
|
| Clean Up | Clean
overspray immediately after use with paint thinner. For storage after
use, clear nozzle immediately after use by holding can upside down,
spraying 2-3 seconds or until paint no longer sprays out of can.
|
| Environmental Concerns | Compliant
with all U.S. VOC regulations for aerosol paint. Contains no methylene
chloride or any ozone damaging fluorocarbons.
|
|
Caution |
Technical Information |
||||||||||||||||||||
|
VAPOR HARMFUL. MAY AFFECT THE BRAIN OR
NERVOUS SYSTEM CAUSING DIZZINESS, HEADACHE OR NAUSEA. CAUSES EYE,
SKIN, NOSE AND THROAT IRRITATION. Do not puncture or incinerate (burn)
container. Exposure to heat or prolonged exposure to sun may cause
bursting. Do not expose to heat or store at temperatures above 120ºF
(49ºC).
Notice: Reports have associated repeated and prolonged occupational over exposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling contents may be harmful or fatal. Vapors may ignite explosively. Keep away from heat, sparks and flame. Do not smoke. Extinguish all flames and pilot lights, turn off stoves, heaters, electric motors and other sources of ignition during use and until all vapors are gone. Prevent build-up of vapors by opening all windows and doors to achieve cross-ventilation. Use only with adequate ventilation. Do not breathe dust, vapors or spray mist. Open windows and doors or use other means to ensure fresh air entry during application and drying. If you experience eye watering, headaches or dizziness, increase fresh air or wear respiratory equipment protection (NIOSH/MSHA approved) or leave the area. Close container after each use. Avoid contact with eyes, skin and clothing. First Aid: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued difficulty is experienced get medical attention immediately. In case of eye contact, flush immediately with plenty of water for at least 15 minutes and get medical attention; for skin, wash thoroughly with soap and water. KEEP OUT OF REACH OF CHILDREN Manufactured For: |
Packaging: aerosol – 10 oz. by wt. (283 g) Colors: 19 colors
|