Technical Bulletin
Cover Shield™
|
|
Technical Bulletin |
|
|
Cover Shield™ |
||
|
ALLPRO®
Corporation |
AP7000 - 11069 |
| Description | ALLPRO
Cover Shield™ Stain Killer is a high hiding flat white polyester coating
that seals stains caused by: smoke, water, lipstick, ink crayons, grease
and similar household products. Ideal for use on plaster, drywall, concrete,
stone, tile, plastic & bare, non-bleeding wood. Excellent primer sealer
compatible with most latex & oil-based paints. |
| Prominent Features |
» Quick drying primer/sealer
|
| Uses |
Excellent for plaster, drywall, concrete, stone, tile, plastic, laminates, aluminum, galvanized & interior steel, bare, non-bleeding wood.
|
| Limitations |
Not for use on rusty metal or bleeding wood surfaces.
|
| Surface Preparation | Clean
surface thoroughly, removing all dirt, grease, oil, soapy film, rust,
moisture, etc. and cover adjacent areas to protect from spray mist.
|
| Application | Use
in well ventilated area. Shake can vigorously for one minute before spraying
and occasionally while in use. Hold can 8 - 10 inches from surface to
be sprayed. Spray at room temperatures between 70ºF - 90ºF (21 - 32ºC).
For best results, apply thin even coats – two thin coats are better than
one heavy one. Recoat within 2 hours or after 48 hours. If nozzle clogs
during use, turn spray button ¼ turn or remove and clean button slot.
Do not stick objects into can opening.
|
| Clean Up | Clean
overspray immediately after use with paint thinner. For storage after
use, clear nozzle immediately after use by holding can upside down, spraying
2-3 seconds or until paint no longer sprays out of can.
|
| Environmental Concerns | Compliant
with all US VOC regulations for aerosol paint. Contains no methylene chloride
or any ozone damaging fluorocarbons.
|
|
Caution |
Technical Information |
||||||||||||||||||||||
|
VAPOR DANGER! EXTREMELY FLAMMABLE LIQUID AND VAPOR. VAPORS MAY CAUSE FLASH FIRE. CONTENTS UNDER PRESSURE. Contains Toluol, Acetone, VM&P Naphtha, Propane, N-Butane, Titanium Dioxide, Xylol, & Ethyl Benzene. VAPOR HARMFUL. MAY AFFECT THE BRAIN OR NERVOUS SYSTEM CAUSING DIZZINESS, HEADACHE OR NAUSEA. CAUSES EYE, SKIN, NOSE AND THROAT IRRITATION. Do not puncture or incinerate (burn) container. Exposure to heat or prolonged exposure to sun may cause bursting. Do not expose to heat or store at temperatures above 120ºF (49ºC). Notice: Reports have associated repeated and prolonged occupational over exposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling contents may be harmful or fatal. Vapors may ignite explosively. Keep away from heat, sparks and flame. Do not smoke. Extinguish all flames and pilot lights, turn off stoves, heaters, electric motors and other sources of ignition during use and until all vapors are gone. Prevent buildup of vapors by opening all windows and doors to achieve cross-ventilation. Use only with adequate ventilation. Do not breathe dust, vapors or spray mist. Open windows and doors or use other means to ensure fresh air entry during application and drying. If you experience eye watering, headaches or dizziness, increase fresh air or wear respiratory equipment protection (NIOSH/MSHA approved) or leave the area. Close container after each use. Avoid contact with eyes, skin and clothing. First Aid: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued difficulty is experienced get medical attention immediately. In case of eye contact, flush immediately with plenty of water for at least 15 minutes and get medical attention; for skin, wash thoroughly with soap and water. KEEP OUT OF REACH OF CHILDREN WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. Manufactured For: |
Packaging: aerosol – 12 oz. by wt.
(340 g). 6 per case
|