Technical Bulletin
Vinyl-Over-Vinyl 620
|
|
Technical Bulletin |
|
|
Vinyl-Over-Vinyl 620 |
||
|
ALLPRO®
Corporation |
AP6750 - 60510 |
| Description | VINYL OVER VINYL™
is a high tack, high solids, heavy-duty adhesive for hanging new vinyl
wallcovering over existing vinyl wallcovering. If applying vinyl
borders, use ALLPRO® BORDER ADHESIVE - as it has extra built-in slip.
|
| Prominent Features |
|
| Uses | Recommended for
vinyl over vinyl applications in commercial use . |
| Limitations | Not recommended
for hanging over existing Tedlar or Teflon coated wallcoverings. Keep
from freezing. |
| Surface Preparation | Surfaces must be
free from grease and other residues, dry, smooth and structurally sound.
Be certain existing wallcovering is firmly attached to the wall. Repair
or remove all loose wallcoverings. Before proceeding with any unusual
conditions, consult your adhesive or wallcovering supplier. |
| Application | Use only when the
room temperature is above 50ºF (10ºC). Apply a thin, even coat of
adhesive. IMPORTANT NOTE: a thick coat is less effective than a thin
coat. Avoid contact with the surface of embossed, textured or delicate
wallcoverings. On existing heavily embossed wallcovering,
VINYL-OVER-VINYL should be applied to both the existing surface and the
new vinyl wallcovering. |
| Clean Up | Before the
adhesive dries, remove excess with clean, warm water. Additional effort
may be required if the adhesive is allowed to contact the surface of
embossed or textured vinyls. IMPORTANT NOTE: the adhesive will be very
difficult to clean up after it is dry. |
| Disposal | Contains organic
solvents which may cause adverse effects to the environment if disposed
of improperly. Place empty containers in normal refuse for
disposal. Contact your local sanitation department or household
hazardous waste coordinator for information concerning possible reuse or
disposal of unused solvent-containing paints, primers or adhesives. |
| Limited Warranty | If,
within twelve months of manufacture and used as directed, this product
is found defective in material or workmanship, it will be replaced
without charge upon presentation of proof of purchase and this used
container. This warranty is in lieu of any other, the exclusive remedy
is limited to replacement of product and ALLPRO disclaims all liability
for consequential damages. Conditions of use are beyond our control.
|
|
Caution |
Technical Information |
| Do
not freeze. Do not take internally. In case of ingestion, seek medical
attention. Avoid contact with skin and eyes. Use of skin and eye
protection is recommended at all times. If contact with eye occurs,
flush with water for 15 minutes. If skin contact occurs, wash with soap
and water. Seek medical attention if rash or other symptoms occur. Do
not mix with other chemicals. Use in a well ventilated work area. Close
containers after each use. Keep out of reach of children.
Manufactured For: |
Packaging:
Vinyl tubs Color: Light Tan Weight per Gallon: approx. 9.4 lbs. % Solids by Weight: approx 55% Viscosity: approx. 17,000 cps - Brookfield viscometer Spreading Rate: approx. 160 sq. ft. per gal. Shelf Life: 1 year minimum Freeze Thaw: Do not freeze Dry Time: Varies depending on temperature and relative humidity Flash Point: Nonflammable Odor: Very low Storage: Avoid freezing; keep in cool, dry place Vehicle: Modified starch and synthetic acrylic polymer Air Quality Data: VOC (calculated) 211 g/l Analysis:
|