Technical Bulletin
Ultra-Prep™ 685
|
|
Technical Bulletin |
|
|
Ultra-Prep™ 685 |
||
|
ALLPRO®
Corporation |
AP6750 - 61281 |
| Description | ULTRA•PREP™
is a premium all-purpose, water-based pigmented primer/sealer which is
extremely water resistant. It provides an ideal surface for wallcovering
installations. ULTRA•PREP can be used in most applications instead of
oil based primers.
|
| Prominent Features |
|
| Uses | Recommend to
prepare surface for double cutting, to seal chalky paint, or to provide
white background for hanging translucent wallcoverings. To prep new
drywall. Compatible with all water or oil/alkyd based products and all
ALLPRO® adhesives.
|
| Limitations | Not recommended
for exterior applications. Ready for wallpaper hanging after dry -
usually one hour for untinted product. Allow overnight drying if product
is tinted.
|
| Surface Preparation | Surface must be
free from grease and other residues, dry, smooth and structurally sound.
Check surfaces for paint bonding, loose wallcoverings, damaged wallboard
or plaster by cutting a small X with a sharp knife and attempt removal
with a small piece of "Scotch" tape. Repair all unsound
surfaces. Before proceeding with any unusual conditions, consult your
adhesive or wallcovering supplier.
|
| Application | Use only when the
room temperature is above 50ºF (10ºC). Apply a full-bodied thin, even
coat of primer with a brush, roller, or spraying system. Do not dilute.
Suggested settings for airless spray:
|
| Clean Up | Before primer
dries, remove the excess with clean water. Brushes and rollers should be
cleaned immediately after use with warm, clean water.
|
| Disposal | ULTRA•PREP is
water based and does not contain organic solvents. Place empty
containers in normal refuse for disposal. Contact your local sanitation
department or household hazardous waste coordinator for information
concerning possible reuse or disposal of unused water based paints,
primers or adhesives.
|
| Limited Warranty | If,
within twelve months of manufacture and used as directed, this product
is found defective in material or workmanship, it will be replaced
without charge upon presentation of proof of purchase and this used
container. This warranty is in lieu of any other, the exclusive remedy
is limited to replacement of product and ALLPRO disclaims all liability
for consequential damages. Conditions of use are beyond our control.
|
|
Caution |
Technical Information |
| Do
not freeze. Do not take internally. In case of ingestion, seek medical
attention. Avoid contact with skin and eyes. Use of skin and eye
protection is recommended at all times. If contact with the eye occurs,
flush with water for 15 minutes. If skin contact occurs, wash with soap
and water. Seek medical attention if rash or other symptoms occur. Use
in a well ventilated work area. Close containers after each use. Keep
out of reach of children.
Manufactured For: |
Packaging:
Metal Can Color: White Weight per Gallon: approx. 10.1 lbs. % Solids by Weight: approx. 43% Viscosity: approx. 6,500 cps -Brookfield viscometer Spreading Rate: 500-600 sq. ft. per gal. @ 2.5 to 3.5 mils wet film thickness Shelf Life: 1 year minimum Freeze Thaw: Do not freeze Dry Time: Varies depending on temperature and relative humidity Flash Point: Nonflammable Odor: Low odor Storage: Avoid freezing; keep in cool, dry place Vehicle: 100% acrylic resin Air Quality Data: VOC (calculated) 43 g/l Analysis:
|