Technical Bulletin
SUP-R-PREP 670
|
|
Technical Bulletin |
|
|
SUP-R-PREP 670 |
||
|
ALLPRO®
Corporation |
AP6750 - 61110 |
| Description | SUP•R•PREP™
is an adhesion promoting primer/sealer for difficult surfaces. It dries
fast to a permanent tack. This tack improves the holding power and
workability of the wallcovering. Excellent for vinyl-over-vinyl
applications.
|
| Prominent Features |
|
| Uses | Recommended for
glass, Formica, tile or any surface where extra adhesion is needed.
Compatible with all water or oil/alkyd based products and all ALLPRO®
adhesives.
|
| Limitations | Not recommended
for exterior applications or bare drywall where future strippability is
desired. Ready for wallpaper hanging after dry - usually one hour for
untinted product. Allow overnight drying if product is tinted.
|
| Surface Preparation | Surface must be
free from grease and other residues, dry, smooth and structurally sound.
Check surfaces for paint bonding, loose wallcoverings, damaged wallboard
or plaster by cutting a small X with a sharp knife and attempt removal
with a small piece of "Scotch" tape. Repair all unsound
surfaces. Before proceeding with any unusual conditions, consult your
adhesive or wallcovering supplier.
|
| Application | Use only when the
room temperature is above 50ºF (10ºC). Apply a full-bodied thin, even
coat of primer with a brush, roller, or spraying system. Do not dilute.
Suggested settings for airless spray:
|
| Clean Up | Before primer
dries, remove the excess with clean water. Brushes and rollers should be
cleaned immediately after use with warm, clean water.
|
| Disposal | SUP•R•PREP is
water based and does not contain organic solvents. Place empty
containers in normal refuse for disposal. Contact your local sanitation
department or household hazardous waste coordinator for information
concerning possible reuse or disposal of unused water based paints,
primers or adhesives.
|
| Limited Warranty | If,
within twelve months of manufacture and used as directed, this product
is found defective in material or workmanship, it will be replaced
without charge upon presentation of proof of purchase and this used
container. This warranty is in lieu of any other, the exclusive remedy
is limited to replacement of product and ALLPRO disclaims all liability
for consequential damages. Conditions of use are beyond our control.
|
|
Caution |
Technical Information |
| Do
not freeze. Do not take internally. In case of ingestion, seek medical
attention. Avoid contact with skin and eyes. Use of skin and eye
protection is recommended at all times. If contact with the eye occurs,
flush with water for 15 minutes. If skin contact occurs, wash with soap
and water. Seek medical attention if rash or other symptoms occur. Use
in a well ventilated work area. Close containers after each use. Keep
out of reach of children.
Manufactured For: |
Packaging:
Metal Can Color: White Weight per Gallon: approx. 8.4 lbs. % Solids by Weight: approx. 24% Viscosity: 3000 cps - Brookfield viscometer Spreading Rate: approx. 400 sq. ft. per gallon @ 4 mils wet film thickness Shelf Life: 1 year minimum Freeze Thaw: Do not freeze Dry Time: Varies depending on temperature and relative humidity Flash Point: Nonflammable Odor: Low odor Storage: Avoid freezing; keep in cool, dry place Vehicle: 100% acrylic resin Air Quality Data: VOC (calculated) 26 g/l Analysis:
|