Technical Bulletin
Pro-Duty™ 3400
|
|
Technical Bulletin |
|
|
Pro-Duty™ 3400 |
||
|
ALLPRO®
Corporation |
AP6750 - 60341 |
| Description | PRO•DUTY™ is
a wheat starch-based adhesive for applying commercial weight
wallcoverings. It dries clear, is non-staining and strippable.
|
| Prominent Features |
|
| Uses | Recommended for
paper-backed and heavyweight vinyls, mylars, naugahyde, heavy weight
foils, burlaps and other synthetic fabrics weighing up to 34 oz.
Strippable when used with fabric-backed vinyl wall-coverings. Compatible
with all wallcovering primers.
|
| Limitations | Not recommended
for direct application over oil/alkyd primers. Keep from freezing.
|
| Surface Preparation | Surface must be
clean, dry and free from dirt, dust, grease, oil, mildew, wax, loose
paint or wallcovering. Check surfaces for paint bonding, loose
wallcoverings, damaged wallboard or plaster by cutting a small X with a
sharp knife and attempt removal with a small piece of "Scotch"
tape. Repair all unsound surfaces. Prime all surfaces (including
oil-based coatings) with an acrylic primer, such as ALLPRO®
E•Z PREP™, SUP•R•PREP™ or ULTRA•PREP™. Before proceeding
with any unusual conditions, consult your adhesive or wallcovering
supplier.
|
| Application | Use only when the
adhesive, wallcovering and surface temperatures are above 50ºF (10ºC).
Apply a thin, even coat of adhesive with a pasting machine, brush or
roller. Avoid contact with the surface of embossed, textured or delicate
wallcoverings. For pasting machine use, thin with a maximum of 1 pint of
clean water per gallon. Book according to the wallcovering manufacturer's
instructions.
|
| Clean Up | Clean all
equipment immediately after use with warm, clean water. Additional
effort may be required if the adhesive is allowed to contact the surface
of embossed or textured vinyls.
|
| Disposal | PRO•DUTY is
water based and does not contain organic solvents. Place empty
containers in normal refuse for disposal. Contact your local sanitation
department or household hazardous waste coordinator for information
concerning possible reuse or disposal of unused water based paints,
primers or adhesives.
|
| Limited Warranty | If,
within twelve months of manufacture and used as directed, this product
is found defective in material or workmanship, it will be replaced
without charge upon presentation of proof of purchase and this used
container. This warranty is in lieu of any other, the exclusive remedy
is limited to replacement of product and ALLPRO disclaims all liability
for consequential damages. Conditions of use are beyond our control.
|
|
Caution |
Technical Information |
| Do
not freeze. Do not take internally. In case of ingestion, seek medical
attention. Avoid contact with skin and eyes. Use of skin and eye
protection is recommended at all times. If contact with eyes occurs,
flush with water for 15 minutes. If skin contact occurs, wash with soap
and water. Seek medical attention if rash or other symptoms occur. Do
not mix with other chemicals. Use in a well ventilated work area. Close
container after each use. Keep out of reach of children.
Manufactured For: |
Packaging:
Vinyl tubs Color: White Weight per Gallon: approx. 8.65 lbs. % Solids by Weight: approx. 16% Viscosity: approx. 90,000 cps Spreading Rate: approx. 180 sq. ft. per gal. Shelf Life: 1 year minimum Freeze Thaw: Do not freeze Dry Time: Varies depending on temperature, ventilation and humidity of the room. Flash Point: Nonflammable Odor: Very low Storage: Avoid freezing; keep in cool, dry place Vehicle: Wheat base Air Quality Data: VOC (calculated) <50 g/l Analysis:
|