Technical Bulletin
Clear-Hang™ 610
|
|
Technical Bulletin |
|
|
Clear-Hang™ 610 |
||
|
ALLPRO®
Corporation |
AP6750 - 60110 |
| Description | Clear Hang™ is
a commercial grade adhesive designed for contractors.
|
| Prominent Features |
|
| Uses | Recommended for
hanging light to medium weight commercial wallcoverings. Compatible with
all ALLPRO® wallcovering primers.
|
| Limitations | Not recommended
for direct application over oil/alkyd primers or paints.
Keep from freezing.
|
| Surface Preparation | Surface must be
clean, dry and free from dirt, dust, grease, oil, mildew, wax, loose
paint or wallcovering. Check surfaces for paint bonding, loose
wallcoverings, damaged wallboard or plaster by cutting a small X with a
sharp knife and attempt removal with a small piece of "Scotch"
tape. Repair all unsound surfaces. Prime all surfaces (including
oil-based coatings) with an acrylic primer such as ALLPRO E•Z• PREP™,
SUP•R•PREP™ or ULTRA•PREP™. Before proceeding with any unusual
conditions, consult your adhesive or wallcovering supplier.
|
| Application | Use only when the
adhesive, wallcovering and surface temperatures are above 50ºF (10ºC).
Apply a thin, even coat of adhesive with a pasting machine, brush or
roller. Avoid contact with the surface of embossed, textured or delicate
wallcoverings. Book according to the wallcovering manufacturer's
instructions. Dilute by adding up to one pint of water per gallon, if
necessary.
|
| Clean Up | Before the
adhesive dries, remove the excess with clean water. Additional effort
may be required if the adhesive is allowed to contact the surface of
embossed or textured vinyls.
|
| Disposal | CLEAR HANG is
water based and does not contain organic solvents. Place empty
containers in normal refuse for disposal. Contact your local sanitation
department or household hazardous waste coordinator for information
concerning possible reuse or disposal of unused water based paints,
primers or adhesives.
|
| Limited Warranty | If,
within twelve months of manufacture and used as directed, this product
is found defective in material or workmanship, it will be replaced
without charge upon presentation of proof of purchase and this used
container. This warranty is in lieu of any other, the exclusive remedy
is limited to replacement of product and ALLPRO disclaims all liability
for consequential damages. Conditions of use are beyond our control.
|
|
Caution |
Technical Information |
| Do
not freeze. Do not take internally. In case of ingestion, seek medical
attention. Avoid contact with skin and eyes. Use of skin and eye
protection is recommended at all times. If contact with eyes occurs,
flush with water for 15 minutes. If skin contact occurs, wash with soap
and water. Seek medical attention if rash or other symptoms occur. Do
not mix with other chemicals. Use in a well ventilated work area. Close
containers after each use. Keep out of reach of children.
Manufactured For: |
Packaging:
Vinyl Tub Color: Off White Weight per Gallon: approx. 8.9 lbs. % Solids by Weight: approx. 23% Viscosity: 30,000 cps - Brookfield viscometer Spreading Rate: Approximately 180 sq. ft. per gallon Shelf Life: 1 year minimum Freeze Thaw: Do not freeze Dry Time: Varies depending on temperature and relative humidity of the room Flash Point: Nonflammable, water-based Odor: Very low Storage: Avoid freezing; keep in cool, dry place Vehicle: Modified starches Air Quality Data: VOC (calculated) 24 g/l Analysis:
|