Technical Bulletin
Clay Strippable 661
|
|
Technical Bulletin |
|
|
Clay Strippable 661 |
||
|
ALLPRO®
Corporation |
AP6750 -60061 |
| Description | Clay Strippable
is a commercial grade adhesive which is strippable with fabric-backed
wallcoverings over bare drywall.
|
| Prominent Features |
|
| Uses | Recommended for
all weights of wallcoverings. Compatible with all ALLPRO® primers.
|
| Limitations | Not recommended
for direct application over oil/alkyd primers or paints.
|
| Surface Preparation | Surface must be
free from grease and other residues, dry, smooth and structurally sound.
Check surfaces for paint bonding, loose wallcoverings, damaged wallboard
or plaster by cutting a small X with a sharp knife and attempt removal
with a small piece of "Scotch" tape. Repair all unsound
surfaces. Prime all surfaces (including oil-based coatings) with an
acrylic primer such as ALLPRO E•Z• PREP™, SUP•R•PREP™ or
ULTRA•PREP™. Before proceeding with any unusual conditions, consult
your adhesive or wallcovering supplier.
|
| Application | Use only when the
room temperature is above 50ºF (10ºC). Apply a thin, even coat of
adhesive with a pasting machine, brush or roller. Dilute by adding up to
one pint of water per gallon, if needed. Avoid contact with surface of
embossed, textured or delicate wallcoverings. Book according to the
wallcovering manufacturer's instructions. For pasting machine use,
thin with a maximum of one pint of water per gallon of adhesive.
|
| Clean Up | Before adhesive
dries, remove the excess with clean water. Additional effort may be
required if the adhesive is allowed to contact the surface of embossed
or textured vinyls.
|
| Disposal | Clay Strippable
is water based and does not contain organic solvents. Place empty
containers in normal refuse for disposal. Contact your local sanitation
department or household hazardous waste coordinator for information
concerning possible reuse or disposal of unused water based paints,
primers or adhesives.
|
| Limited Warranty | If,
within twelve months of manufacture and used as directed, this product
is found defective in material or workmanship, it will be replaced
without charge upon presentation of proof of purchase and this used
container. This warranty is in lieu of any other, the exclusive remedy
is limited to replacement of product and ALLPRO disclaims all liability
for consequential damages. Conditions of use are beyond our control.
|
|
Caution |
Technical Information |
| Do
not freeze. Do not take internally. In case of ingestion, seek medical
attention. Avoid contact with skin and eyes. Use of skin and eye
protection is recommended at all times. If contact with eye occurs,
flush with water for 15 minutes. If skin contact occurs, wash with soap
and water. Seek medical attention if rash or other symptoms occur. Do
not mix with any other chemicals. Use in a well ventilated work area.
Close containers after each use. Keep out of reach of children.
Manufactured For: |
Packaging:
Vinyl tubs Color: Tan Weight per Gallon: approx. 9.75 lbs. % Solids by Weight: approx. 32% Viscosity: Approximately 50,000 cps - Brookfield viscometer Spreading Rate: Approximately 200 sq. ft. Shelf Life: 1 year minimum Freeze Thaw: Do not freeze Dry Time: Drying time will vary depending on temperature and relative humidity. Flash Point: Nonflammable Odor: Very low Storage: Avoid freezing; keep in cool, dry place. Vehicle: Clay & modified starches Air Quality Data: VOC (calculated) 17g/l Analysis: |