Technical Bulletin
Professional Border Adhesive 640
|
|
Technical Bulletin |
|
|
Professional Border Adhesive 640 |
||
|
ALLPRO®
Corporation |
AP6750 - 60504 |
| Description | ALLPRO®
Border Adhesive is a professional high tack adhesive designed
specifically for hanging borders over vinyl wallcovering. It is much
better suited for hanging borders than commercial vinyl-over-vinyl
products.
|
| Prominent Features |
|
| Uses | Recommended for
hanging borders over existing wallcovering including vinyls.
|
| Limitations | Not recommended
for use on painted surfaces, primed or bare drywall, nor rough surfaces
such as concrete block, stucco, and rough plaster.
|
| Surface Preparation | Surface must be
free from grease and other residues, dry, smooth and structurally sound.
Check surfaces for loose wallcoverings. Repair all unsound surfaces.
Before proceeding with any unusual conditions, consult your adhesive or
wallcovering supplier.
|
| Application | Use only when the
room temperature is above 50ºF (10ºC). For best results, moisten the
back of pre-pasted borders with a damp sponge. Apply a full-bodied,
thin, even coat that covers the entire surface. IMPORTANT NOTE: a thick
coat is less effective than a thin coat. Avoid contact with the front of
the border.
|
| Clean Up | Before the
adhesive dries, remove excess with warm, clean water. Additional effort
may be required if the adhesive is allowed to contact the surface of
embossed or textured vinyls. IMPORTANT NOTE: the adhesive will be very
difficult to clean up after it is dry.
|
| Disposal | Contains organic
solvents which may cause adverse effects to the environment if disposed
of improperly. Place empty containers in normal refuse for
disposal. Contact your local sanitation department or household
hazardous waste coordinator for information concerning possible reuse or
disposal of unused solvent-containing paints, primers or adhesives.
|
| Limited Warranty | If,
within twelve months of manufacture and used as directed, this product
is found defective in material or workmanship, it will be replaced
without charge upon presentation of proof of purchase and this used
container. This warranty is in lieu of any other, the exclusive remedy
is limited to replacement of product and ALLPRO disclaims all liability
for consequential damages. Conditions of use are beyond our control.
|
|
Caution |
Technical Information |
| Do
not freeze. Do not take internally. In case of ingestion, seek medical
attention. Avoid contact with skin and eyes. Use of skin and eye
protection is recommended at all times. If contact with eye occurs,
flush with water for 15 minutes. If skin contact occurs, wash with soap
and water. Seek medical attention if rash or other symptoms occur. Do
not mix with other chemicals. Use in a well ventilated work area. Close
containers after each use. Keep out of reach of children.
Manufactured For:
|
Packaging:
Vinyl tubs Color: White Weight per Gallon: approx. 8.4 lbs. % Solids by Weight: approx. 23% Viscosity: approx. 24,000 cps-Brookfield viscometer Spreading Rate: approx. 160 sq. ft. per gal. Shelf Life: 1 year minimum Freeze Thaw: Do not freeze Dry Time: Varies depending on temperature and relative humidity Flash Point: Nonflammable Odor: Low odor Storage: Avoid freezing; keep in cool, dry place. Vehicle: Synthetic Polymer Air Quality Data: VOC (calculated) 120 g/l Analysis:
|