Technical Bulletin
Add-A-Bond™ 665
|
|
Technical Bulletin |
|
|
Add-A-Bond™ 665 |
||
|
ALLPRO®
Corporation |
AP6750 - 60910 |
| Description | ADD•A•BOND™
activator for pre-pasted wallpaper is designed to save the professional
time and money. It also assists the do-it-yourselfer in having a better
wallpaper hanging experience. |
| Prominent Features |
|
| Uses | Recommended for
pre-pasted wallcoverings and for pre-pasted borders on primed or painted
surfaces. |
| Limitations | Not recommended
for direct application over oil/alkyd primers or paints. Do not use for
applying new pre-pasted wallcovering over existing vinyl wallcovering,
instead use ALLPRO® Vinyl-Over-Vinyl™ adhesive. |
| Surface Preparation | Surface must be
free from grease and other residues, dry, smooth and structurally sound.
Check surfaces for paint bonding, loose wallcoverings, damaged wallboard
or plaster by cutting a small X with a sharp knife and attempt removal
with a small piece of "Scotch" tape. Repair all unsound
surfaces. Prime all surfaces (including oil-based coatings) with an
acrylic primer, such as ALLPRO® E•Z• PREP™, SUP•R•PREP™, or
ULTRA•PREP™. Before proceeding with any unusual conditions, consult
your adhesive or wallcovering supplier. |
| Application | Use only when the
room temperature is above 50ºF (10ºC). Apply a full-bodied thin, even
coat of activator with a pasting machine, brush or roller. Do not dilute
or thin. Book according to the wallcovering manufacturer's
instructions. |
| Clean Up | Before the
adhesive dries, remove excess with clean water. Clean all equipment
immediately after use with warm, clean water. |
| Disposal | ADD•A•BOND is
water based and does not contain organic solvents. Place empty
containers in normal refuse for disposal. Contact your local sanitation
department or household hazardous waste coordinator for information
concerning possible reuse or disposal of unused water based paints,
primers or adhesives. |
| Limited Warranty | If,
within twelve months of manufacture and used as directed, this product
is found defective in material or workmanship, it will be replaced
without charge upon presentation of proof of purchase and this used
container. This warranty is in lieu of any other, the exclusive remedy
is limited to replacement of product and ALLPRO disclaims all liability
for consequential damages. Conditions of use are beyond our control.
|
|
Caution |
Technical Information |
| Do
not freeze. Do not take internally. In case of ingestion, seek medical
attention. Avoid contact with skin and eyes. Use of skin and eye
protection is recommended at all times. If contact with the eye occurs,
flush with water for 15 minutes. If skin contact occurs, wash with soap
and water. Seek medical attention if rash or other symptoms occur. Do
not mix with any other chemicals. Use in a well ventilated work area.
Close containers after each use. Keep out of reach of children.
Manufactured For:
|
Packaging:
Vinyl tubs Color: Translucent Weight per Gallon: 8.4 lbs. % Solids by Weight: approx. 3% Viscosity: Approximately 3,500 cps - Brookfield viscometer Spreading Rate: approx. 360 sq. ft. per gal. Shelf Life: 1 year minimum Freeze Thaw: Do not freeze Dry Time: Varies depending on temperature and relative humidity Flash Point: Nonflammable Odor: Very low Storage: Avoid freezing; keep in cool, dry place Vehicle: Modified starches Air Quality Data: VOC (calculated) 40 g/l Analysis: |