Technical Bulletin
E•Z PASTE™
|
|
Technical Bulletin |
|
|
E•Z PASTE™ |
||
|
ALLPRO®
Corporation |
AP6750 - 60170 |
| Description | E•Z
PASTE Universal Wallcovering and Border Adhesive is a synthetic polymer-based
adhesive designed to hang all borders and wallcovering over any surface. |
| Prominent Features |
|
| Uses |
Recommended for hanging borders or wallcovering over sound latex paint or wallpaper. Can also be used to hang non-woven wallcovering (different hanging instructions.)
|
| Limitations | Keep
from freezing. |
| Surface Preparation | Surface must be
clean, dry and free from dirt, dust, grease, oil, mildew, wax or loose
paint. Check surfaces for paint bonding, damaged wallboard or plaster
by cutting a small X with a sharp knife and attempt removal with a small
piece of "Scotch" tape. Repair all unsound surfaces. Prime all surfaces
(including oil-based coatings) with ALLPRO® ULTRA•PREP™ acrylic primer.
Before proceeding with any unusual conditions, consult your adhesive or
wallcovering supplier. |
| Application |
Use only when the adhesive, wallcovering and surface temperatures are above 50ºF (10ºC). Do not dilute. Apply a uniform coat of adhesive with a brush or roller to one sheet at a time. Avoid contact with the surface of embossed, textured or delicate wallcoverings. Book according to the wallcovering manufacturer's instructions. Do not overbook. HANGING NON-WOVEN WALLPAPERSurface must
be primed with ALLPRO® ULTRA•PREP™ acrylic primer. Paste the wall
with E•Z PASTE™. Hang wallcovering on the wall. |
| Clean Up | Clean all equipment
and wallcovering surfaces immediately after use with warm, clean water
with frequent changes of water. Additional effort may be required if the
adhesive is allowed to contact the surface of embossed or textured vinyls. |
| Disposal | E•Z PASTE
is water based and does not contain organic solvents. Place empty containers
in normal refuse for disposal. Contact your local sanitation department
or household hazardous waste coordinator for information concerning possible
reuse or disposal of unused water based paints, primers or adhesives. |
| Limited Warranty | If,
within 24 months of manufacture and used as directed, this product is
found defective in material or workmanship, it will be replaced without
charge upon presentation of proof of purchase and the used container.
This warranty is in lieu of any other, the exclusive remedy is limited
to replacement of product and ALLPRO disclaims all liability for consequential
damages. Conditions of use are beyond our control.
|
|
Caution |
Technical Information |
| Avoid
breathing of vapors or spray mist. Do not freeze. Do not take internally.
In case of ingestion, seek medical attention. Avoid contact with skin
and eyes. As with all coatings, it is recommended to use skin and eye
protection at all times. If contact with eye occurs, flush with water
for 15 minutes. If skin contact occurs, wash with soap and water. Seek
medical attention if rash or other symptoms occur. Do not mix with other
chemicals. Use in a well ventilated work area. Close containers after
each use. Keep out of reach of children.
Manufactured For:
|
Packaging:
Vinyl tubs Color: White Weight per Gallon: 8.4 lbs. % Solids by Weight: approx. 15% Viscosity: Approximately 13,000-15,000 cps - Brookfield viscometer Spreading Rate: approx. 250 sq. ft. per gal. Shelf Life: 1 year minimum Freeze Thaw: Do not freeze Dry Time: Varies depending on temperature and relative humidity Flash Point: Nonflammable Odor: Very low Storage: Indoor, dry place. Protect from freezing. Vehicle: Synthetic Polymer Air Quality Data: VOC (calculated) <50 g/l Analysis: |