Acrylic Urethane Waterborne Clear Finish Reducer

Description	Ideal for use in situations where there is a need to improve flow and reduce the problem of bubbles, sagging and poor leveling. Under certain application methods or ambient conditions, waterborne coatings may require the addition of ALLPRO Reducer to improve flow and leveling, increasing the open time. Another benefit of ALLPRO Reducer is that it will not raise the wood grain or cause sagging as water does. Naturally, longer open time increases the total curing time of the coating.
Prominent Features	» Improves flow & leveling » Reduces bubbles » Increases open time
Uses	For use in ALLPRO Acrylic Urethane Waterborne Varnishes.
Application	Add between 4 and 8 ounces per gallon, or between 1 and 2 liquid ounces per quart, based on application need. Mix thoroughly and avoid over shaking.
Clean Up	Clean up with warm water. A small amount of ammonia may be added to the water to improve clean up.
Disposal	Contains organic solvents which may cause adverse effects to the environment if disposed of improperly. Place empty containers in normal refuse for disposal. Contact your local sanitation department or household hazardous waste coordinator for information concerning possible reuse or disposal of unused solvent-containing adhesives and/or sealants.

Caution

Technical Information

Do not take internally.

WARNING! CAUSES EYE, SKIN AND RESPIRATORY TRACT IRRITATION. MAY BE HARMFUL IF SWALLOWED. CONTAINS ETHYLENE GLYCOL WHICH CAN CAUSE SEVERE KIDNEY DAMAGE WHEN INGESTED AND HAS BEEN SHOWN TO CAUSE BIRTH DEFECTS IN LABORATORY ANIMALS. POTENTIAL CANCER HAZARD. CONTAINS FORMALDEHYDE WHICH HAS BEEN SHOWN TO CAUSE UPPER RESPIRATORY TRACT CANCER AND ALLERGIC RESPIRATORY REACTION. USE ONLY WITH ADEQUATE VENTILATION. KEEP OUT OF REACH OF CHILDREN.

NOTICE: This product contains solvents. Reports have associated repeated and prolonged overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. This product contains chemicals known to the state of California to cause cancer. For additional information call (800) 323-0633. For additional safety information, refer to the Material Safety Data Sheet for this product. Obtain professional advice before using. Close container after each use. FIRST AID: In case of skin contact, wash off quickly with plenty of soap and water, remove contaminated clothing. For eye contact flush eyes immediately with large quantities of water, for at least 15 minutes. Obtain emergency medical treatment. If swallowed, obtain medical treatment immediately. If inhalation causes physical discomfort, remove to fresh air. If discomfort persists or any breathing difficulty occurs, get medical help.

Manufactured For:
ALLPRO® Corporation
Brandon, FL 33511

Note: The information, ratings and opinions stated above pertain to the material currently offered and represent the results of tests and calculations believed to be reliable.

Packaging: Quart & Gallon
Color: N.A.
Weight per Gallon: 8.5 lbs. per gal.
% Solids by Weight: 0%
% Solids by Volume: 0%
Viscosity: 9 - 10 Sec #4 Ford Cup
Spreading Rate: N/A
Shelf Life: Indefinite
Freeze Thaw: N/A
Dry Time: N/A
Flash Point: Nonflammable
Odor: Low
Storage: Indoors, between 40º F - 100ºF
Vehicle: N/A
Air Quality Data: 8.5 lbs/gal (1011 g/l) VOC/VOS

Analysis:
Water (CAS 7732-18-5)
Glycol (CAS 57-55-6)
Glycol Ether (CAS 112-34-5)

		Technical Bulletin

		Acrylic Urethane Waterborne Varnish Reducer