Technical Bulletin
A4540 HD Acrylic Traffic Marking Paint
|
|
Technical Bulletin |
|
|
A4540 HD Acrylic Traffic Marking Paint |
||
|
ALLPRO®
Corporation |
AP2450 - 30901 |
| Description | A
line of heavy duty vinyl-acetate/acrylic traffic marking paints
formulated for interior and exterior line marking on horizontal surfaces
such as streets, highways, parking lots, warehouses, etc. Available in
White, Black, Yellow (both lead free and leaded), plus Handicap Blue and
Fire Zone Red which meet the requirements of TT-P-1952B.
|
| Prominent Features |
|
| Uses | Used
for marking of traffic lanes on interior and exterior horizontal
surfaces including streets, highways, parking lots, warehouses, etc.
|
| Limitations | Do
not apply when air or surface temperature is below 50ºF. Do not apply
to extremely hot surfaces. Paint only in dry weather. Do not apply to
fresh asphalt. Not designed as an anti-slip coating.
|
| Surface Preparation | The
surface to be coated must be clean and free of dust, grease, wax, rust,
oil and bleeding stains. New asphalt or any asphaltic seal coat applied
to the surface prior to application of HD Acrylic Traffic Marking Paint
should be dry for at least 48 hours before this marking paint is used.
Existing traffic lines can be obliterated on asphalt surfaces by coating
with ALLPRO A4540-102 Black Acrylic Traffic Marking Paint prior to
application of the required color. Allow A4540-102 to dry four (4) hours
before recoating with A4540 HD Acrylic color required.
|
| Application | May
be applied by brush, roller, spray, hand operated or automatic line
markers. Do not apply when air or surface temperature is below 50ºF. Do
not apply to extremely hot surfaces. Stir contents thoroughly from the
bottom before using. Paint only in dry weather. Thinning is not normally
required. If necessary, thin sparingly with clean water. Traffic beads
may be dropped into this coating while wet to provide reflectorized
markings. If beads are applied, they should be broadcast into the wet
paint at a rate of six (6) pounds per gallon of paint.
|
| Clean Up | Clean
up immediately after use with warm soapy water. Promptly and safely
dispose of used rags, container and unused contents in accordance with
local, state and federal regulations.
|
|
Caution |
Technical Information |
|
A4540-101 White CAUTION! DO NOT TAKE INTERNALLY. WARNING! CAUSES EYE, SKIN AND RESPIRATORY TRACT IRRITATION. MAY BE HARMFUL IF SWALLOWED. CONTAINS ETHYLENE GLYCOL WHICH CAN CAUSE SEVER KIDNEY DAMAGE WHEN INGESTED AND HAS BEEN SHOWN TO CAUSE BIRTH DEFECTS IN LABORATORY ANIMALS. POTENTIAL CANCER HAZARD. CONTAINS FORMALDEHYDE WHICH HAS BEEN SHOWN TO CAUSE UPPER RESPIRATORY TRACT CANCER AND ALLERGIC RESPIRATORY REACTION. USE ONLY WITH ADEQUATE VENTILATION. KEEP OUT OF REACH OF CHILDREN. NOTICE: This product contains solvents. Reports have associated repeated and prolonged overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. This product contains chemicals known to the state of California to cause cancer. For additional safety information refer to the Material Safety Data Sheet for this product. Obtain professional advice before using. Close container after each use. FIRST AID: In case of skin contact, wash off quickly with plenty of soap and water, remove contaminated clothing. For eye contact, flush eyes immediately with large quantities of water, for at least 15 minutes. Obtain emergency medical treatment. If swallowed, obtain medical treatment immediately. If inhalation causes physical discomfort, remove to fresh air. If discomfort persists or any breathing difficulty occurs, get medical help. KEEP OUT OF REACH OF CHILDREN. PROTECT FROM FREEZING. ADDITIONAL CAUTION FOR A4540-157 Yellow (leaded) CONTAINS LEAD DRIED FILM OF THIS PAINT MAY BE HARMFUL IF EATEN OR CHEWED. Do not apply on toys and other children's articles, furniture or interior surfaces of any dwelling or facility which may be occupied or used by children. Do not apply on those exterior surfaces of dwelling units, such as windowsills, porches, stairs or railing, to which children may be commonly exposed. Use only with adequate ventilation. Manufactured For: |
Packaging:
Gallons and five gallons Colors: White, Black, Yellow (leaded), Yellow (lead free), Handicap Blue, and Fire Zone Red Specular (60º) Gloss: 1 - 5% @ 85º Weight Per Gallon: 11.55 lbs. % Solids by Weight: 48 % % Solids by Volume: 28% Viscosity: 80 - 85 Krebs Units Recommended Film Thickness- Wet: 12.0 - 15.0 mils Dry: 3.4 - 4.2 mils Spreading Rate - 3" line: 400 feet 4" line: 300 feet 5" line: 240 feet 6" line: 200 feet Dry Time - Tack Free: 30 minutes (ASTM D-711) Recoat: 4 hours Full Cure: 7 days Flash Point: > 200ºF (TT-P-141, Method 4293) Light Reflectance (White or lightest color): 90% Storage: Indoor, protect from freezing Vehicle: Vinyl Acetate/Acrylic Thinner: Clean water Clean Up Solvent: Warm soapy water Federal Specifications - Meets the requirements of TT-P-1952B Air Quality Data: Maximum of 240 grams per liter VOC/VOS (2.0 lbs/gal) of coating. Ingredients A4540-101 CAS # |