ALLPRO^® Corporation
   Brandon, FL 33511

AP2440 - 39005
June, 2007

ALLPRO® Multi-Purpose Water Repellent is a water-based acrylic formula designed to protect and seal a variety of surfaces, both horizontal and vertical.  It’s an excellent dustproofer and resists oil stains and chemicals.  The no-wax, extreme beading formula repels moisture and protects your surface from road salts, freeze/thaw cycles, UV rays, and has excellent “hot tire” mark release.

• Water-based acrylic formula
• Low Odor
• VOCs <100 g/L
• One-Coat Application
• No-Wax, Extreme Beading Formula
• Seals Brick, Pavers, Concrete, Stucco, Wood and More
• Applies Milky-White, Dries Clear
• Non-Yellowing Formula
• Protects Wood from Warping
• Resists Mold and Mildew Growth
• Paintable

ALLPRO® Multi-Purpose Water Repellent seals and protects a variety of surfaces from the damaging effects of water penetration.  It rejuvenates old surfaces and binds and waterproofs aging mortar and brick.  Excellent for sealing vertical or horizontal masonry, brick, stucco, concrete, pottery, stone, pressure-treated wood decks, plywood, pre-cast pavers, exposed aggregate, terrazzo, Chattahoochee, and more.

Use on above grade surfaces only.  Do not apply if rain is expected within 24 hours or if temperatures fall below 55˚F within 24 hours of application. For increased safety, add a clear non-slip additive before application. Keep from freezing.

The critical factor in achieving a lasting finish is surface preparation.  Surface must be clean and dry. Remove loose paint and excessive chalk. Power washing is recommended.  Use a mildewcide on wood surfaces if necessary. Repair cracks and surface breaks. Chemical cleaners must be neutralized prior to application.  Cover windows, doors, etc. and use caution when applying on windy days. 

Read all directions thoroughly. Wear gloves and eye protection.  New concrete must have cured for 30 days prior to application.  DO NOT SHAKE.  ALLPRO® Multi-Purpose Water Repellent is ready to use; do not dilute. Note: Sealer appears milky white during application but dries to a clear semi-gloss finish.

Garden Sprayer: lightly spray surface with a fan-tip spray pattern, then backroll to ensure penetration and prevent puddling.  Remove overspray immediately with water.

Roller: dampen a short-nap (1/4” – 3/8”) roller with water, remove excess, then saturate with sealer.  Roll onto surface keeping a wet edge to avoid streaks.  Do not allow to puddle, foam or run.

Clean all tools immediate after use with soap & water.  Store unused product in a dry place above 50ºF.  Do not use solvent-based cleaners on surface; clean occasionally with a mild soap and water solution.

Caution

Technical Information

KEEP OUT OF REACH OF CHILDREN

For Eye Contact:  Flush with water for 15 minutes
For Skin Contact: Prolonged contact may cause irritation.  Wash affected area with soap and water.
If Swallowed: Induce vomiting and seek immediate medical attention
Inhalation:  If headache or nausea is experienced, remove the individual to fresh air.  If symptoms persist, seek medical attention.

NOTICE: Manufacturer/seller makes no warranty of any kind except that this product is free from defect and is of merchantable quality. Buyer remedy for breach of warranty is limited to replacement of product or refund of purchase price.

Manufactured For:
ALLPRO® Corporation
Brandon, FL 33511

Note: The information, ratings and opinions stated above pertain to the material currently offered and represent the results of tests and calculations believed to be reliable.