MATERIAL SAFTEY DATA SHEET
Coatings, resins, and related materials Page 1
Approved by the U.S. Department of Labor HMIS
"Essentially Similar" to OSHA Form - 174 Health 1
Flammability 0
Reactivity 0
P.P.E B
B28015
Date of preparation: 10/19/98
Supersedes: 00/00/00
Section I - GENERAL INFORMATION
Manufacturer's name and address: Lighthouse/VIP Products
P.O. Box 1253
New Smyrna Beach
Florida 32170
Emergency Telephone Number: (800) 424-9300 Chemtrec
(703) 527-3887 Outside the U.S.
Product class (B): Water/Resin
Complex Mixture
Product reference: AP165-20
Trade Name: ALLPRO All Seal
Section II - HAZARDOUS INGREDIENTS
TLV
Ingredients (CAS No.) % By Wt. PPM Mg/Cum LEL Vapor
Pressure
(mm Hg)
Acryl-Hydrophobe Copolymer Resin
(CAS Unknown) 15.0
2-(2- Methoxyethoxy) Ethanol
(111-77-3) 1.5 NE
Proprietary Benzotriazole Structure
(104810-47-1) 0.2
Bis (1,2,2,6,6-pentamethyl-4-piperridinyl)
Sebacate (41556-26-7) 0.1
Additives (Proprietary) 0.7
Water (7732-18-5) 82.5
MATERIAL SAFETY DATA SHEET Page 2
Product reference: AP165-20 B28015
Trade name: ALLPRO ALL SEAL
Notes: NA= Not Applicable, NE= Not Established, * & ?= See Section IX - SPECIAL
PRECAUTIONS
??= This symbol indicates SECTION 313 SUPPLIER NOTIFICATION. Should (????PREFIX
be shown along-side chemical ingredient then it is important to understand that
this product contains a TOXIC CHEMICAL subject to reporting requirements of
SECTION 313 of the EMERGENCY PLANNING and COMMUNITY RIGHT-TO-KNOW ACT and of CRF
372: NOTICE: This information must be included in all MSDS's that are copied and
distributed for this product.
Section III - PHYSICAL DATA
Boiling range: 212°F.
Vapor density: HEAVIER THAN AIR
Evaporation rate: SLOWER THAN ETHER
Weight per U.S. gallon in pounds: 8.4
Percent volatile - by volume: 85.6
Calculated VOC grams/liter: 46.6
Theoretical VOC pounds/gallon: 0.389
Section IV - FIRE AND EXPLOSION HAZARD DATA
DOT Category: NOT APPLICABLE
Flash point: NOT APPLICABLE
Lower explosion limit (Product): NOT APPLICABLE
Extinguishing media: NON-COMBUSTIBLE, however, for dry solids, use of water,
foam, carbon dioxide, or dry chemical fire fighting apparatus.
Unusual fire and explosion hazards: CLOSED CONTAINERS exposed to extreme heat
may rupture due to pressure build-up. CONTENTS may spatter if temperature
exceeds boiling point (212°F). Dried films are capable of burning.
Special fire fighting procedures: The use of SELF-CONTAINED breathing apparatus
is recommended for fire fighters. WATER may be useful in keeping fire-exposed
containers cool.
Section V - HEALTH HAZARD DATA
Threshold limit value: NOT ESTABLISHED
EFFECTS OF OVER EXPOSURE (FOR PRODUCT):
EYES: Trace amounts of ammonia and residue monomer VAPORS MAY BE IRRITATING TO
THE EYES ESPECIALLY IN POORLY VENTILATED AREAS.
SKIN: This product CAN CAUSE SKIN IRRITATION upon prolonged or repeated contact.
BREATHING: ADVERSE HEALTH EFFECTS FROM VAPORS OR SPRAY MISTS in poorly
ventilated areas may include IRRITATION OF THE MUCOUS MEMBRANES OF THE NOSE,
THROAT, RESPIRATORY TRACT and symptoms of HEADACHE AND NAUSEA.
SWALLOWING: Can cause GASTROINTESTINAL IRRITATION, NAUSEA, VOMITING and
DIARRHEA.
MATERIAL SAFETY DATA SHEET Page 3
Product reference: AP165-20 B28015
Trade name: ALLPRO ALL SEAL
Section V - HEALTH HAZARD DATA (Continued)
EMERGENCY AND FIRST AID PROCEDURES:
IF IN EYES: If this product comes in contact with eyes, FLUSH WITH LARGE
QUANTITIES OF WATER for at least 15 minutes lifting upper and lower lids
occasionally. SEEK MEDICAL ATTENTION.
IF ON SKIN: THOROUGHLY WASH EXPOSED AREA WITH SOAP AND LARGE QUANTITIES OF
WATER FOR AT LEAST 15 MINUTES. REMOVE CONTAMINATED CLOTHING and launder before
use. Seek medical attention if irritation from contact persists.
IF BREATHED: Individual may experience dizziness or light-headedness when
working in poorly ventilated areas. SEEK AIR FREE FROM VAPORS.
IF SWALLOWED: IF VICTIM IS CONSCIOUS INDUCE VOMITING AT ONCE BY GIVING TWO (2)
GLASSES OF WATER TO DRINK AND PLACE FINGER AT BACK OF VICTIM'S THROAT. CALL
PHYSICIAN IMMEDIATELY.
Section VI - REACTIVITY DATA
STABILITY: Stable
CONDITIONS TO AVOID:
INCOMPATIBILITY
(Materials to avoid): No hazardous reactions are expected to occur under normal
usage conditions. However, product properties may be altered by mixing some
materials.
HAZARDOUS DECOMPOSITION: Thermal decomposition may yield oxides of carbon,
toxic monomer fumes, and oxides of nitrogen.
HAZARDOUS POLYMERIZATION: Will not occur.
Section VII - SPILL AND LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
Keep unnecessary people away. Flush spilled material into suitable
retaining area containers with large quantities of water. Small amounts of
spilled material may be absorbed into appropriate absorbent. Prevent spilled
mixture from entering sewers, storm drains, other unauthorized
treatment/drainage systems, and natural waterways.
WASTE DISPOSAL METHOD:
Dispose of product in accordance with applicable local, county, state and
federal regulations.
MATERIAL SAFETY DATA SHEET Page 4
Product reference: AP165-20 B28015
Trade name: ALLPRO ALL SEAL
Section VIII - SPECIAL PROTECTION INFORMATION
RESPIRATORY PROTECTION: None required if GOOD ventilation is maintained. IF
HIGH VAPOR CONCENTRATIONS - USE MSA/NIOSH APPROVED RESPIRATOR WITH FILTERS
DESIGNED TO REMOVE VAPORS AND PARTICULATES.
VENTILATION: PROVIDE SUFFICIENT mechanical (General) and/or local EXHAUST
VENTILATION to maintain exposure below TLV(s).
EYE PROTECTION: SAFETY GLASSES, chemical GOGGLES and/or FACE SHIELDS ARE
RECOMMENDED to safeguard against potential eye contact, irritation and POSSIBLE
CORNEAL DAMAGE.
OTHER PROTECTIVE EQUIPMENT: To prevent repeated or prolonged skin contact the
user should wear impervious clothing and boots.
Section IX - SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING.
* Keep product containers COOL, DRY, and AWAY FROM SOURCES OF IGNITION.
* USE and STORE this product with ADEQUATE VENTILATION.
* Keep product containers CLOSED when not in use.
* AVOID SUBJECTING this product to EXTREME TEMPERATURE VARIATIONS and FREEZING.
* LAUNDER SATURATED CLOTHING BEFORE WEARING.
* Prudent handling practices should be exercised to AVOID UNNECESSARY EXPOSURE.
IMPORTANT INFORMATION (PERSONAL SAFETY).
WARNING: PROPOSITION 65: (California's Safe Drinking Water and Toxic Enforcement
Act of 1986): Paints and Coatings, Solvents, Surface Preparation Materials,
Patching, Caulking, Spackling and related products may contain detectable
traces of various chemicals as unintended contaminants. Some of these chemicals
are known to the state of California to cause cancer and/or birth defects or
other reproductive harm. In absence of extensive scientific testing and
continuous monitoring to demonstrate no significant risk or no observable
effect resulting from exposure to trace contaminants during normal use of the
products mentioned above. This warning is provided pursuant to California
Health Code Section 25249.6.
* AN ASTERISK POSITIONED IN FRONT OF AN INGREDIENT SIGNIFIES A CHEMICAL KNOWN TO
THE STATE OF CALIFORNIA TO CAUSE CANCER, OR BIRTH DEFECTS OR OTHER REPRODUCTIVE
HARM.
Section X - PRECAUTIONARY WARNINGS
(1) Read and adhere to all precautionary warning statements printed on the
label for this complex mixture.
(2) Avoid FREEZING this complex mixture (THE PRODUCT).
(3) Make sure that this complex mixture (THE PRODUCT) IS KEPT OUT OF THE REACH
OF CHILDREN.
MATERIAL SAFETY DATA SHEET Page 5
Product reference: AP165-20 B28015
Trade name: ALLPRO ALL SEAL
Disclaimer: While Coronado Laboratories believes that the data contained herein
are accurate and derived from qualified sources, the data are not to be taken
as a warranty or representation for which Coronado Laboratories assumes legal
responsibility. They are offered solely for your consideration, investigation
and verification. Any use of these data and information must be determined by
the user to be in accordance with applicable Federal, State and local laws and
regulations.
Last page.